Installation Instructions: 150mm+ House Numbers and Letters

floating house number

All House Numbers orders come with a print out of installation instructions, and your installation template. We've also detailed them below if you're wanting to get prepared - or if your instructions have gone missing. 

Step 1

Gather your supplies: house numbers, template, rods and, spacers. Not included: spirit level, tape, suitable glue [eg Liquid Nails] hammer, drill & 5mm drill bit. Brick or concrete may require a hammer drill.

installing house numbers

Step 2

Tape the template at desired location and set spacing between numbers. Use a spirit level to align template. Drill holes according to template using a 5mm drill bit, then remove template.

house number install template

Step 3

Apply a small amount of glue to one end of the studs.

apply glue to house number

Step 4

Push studs into pre-drilled holes on the back side of each number. Light tapping of the rods may be required. If so, place on a soft surface to avoid scratching face of the number.

push studs in to holes

Step 5

Slide spacers over rods and apply a small amount of glue to the end of the exposed rods.

slider spacers over rods

Step 6

Push number into holes. Light tapping with a hammer may be required. Take care to not scratch the face of the number.

push house number into holes

Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.